subject
Physics, 14.02.2020 01:09 vicsmi6191

The first international standard of length was a metal bar kept at the International Bureau of Weights and Measures. One meter of length was defined to be the distance between two fine lines engraved near the ends of the bar. Why was it important that the bar be kept at a constant temperature?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 16:10
Why cooking gas has a typical smell
Answers: 2
question
Physics, 21.06.2019 16:30
The mass of a muon is 207 times the electron mass; the average lifetime of muons at rest is 2.21 μs. in a certain experiment, muons moving through a laboratory are measured to have an average lifetime of 7.04 μs. for the moving muons, what are (a) β (b) k, and (c) p? the rest energy of the electron is 0.511 mev.
Answers: 2
question
Physics, 22.06.2019 00:00
(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.
Answers: 2
question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
You know the right answer?
The first international standard of length was a metal bar kept at the International Bureau of Weigh...
Questions
question
Mathematics, 27.09.2019 07:30