subject
Physics, 27.01.2020 21:31 jazzlashayy1487

Aparticle with charge q on the negative x axis and a second particle with charge 2q on the positive x axis are each a distance d from the origin. where should a third particle with charge 3q be placed so that the magnitude of the electric field at the origin is zero? (use any variable or symbol stated above as necessary.)

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 01:10
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
question
Physics, 22.06.2019 06:00
A1,700kg car is being used to give a 1,400kg car a push start by exerting a force of 140n the impulse on the smaller car during the 30.0s of contact is +670kg*m/s. what is the impulse of the smaller car on the larger car? -814 kg*m/s 0kg *m/s -670kg*m/s -550kg*m/s
Answers: 1
question
Physics, 22.06.2019 08:00
Ms.hidalgo opens the door to her classroom. her classroom is 60 degrees and the air outside is 80. predict what will happen using your knowledge of how heat flows.
Answers: 2
question
Physics, 22.06.2019 08:20
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
You know the right answer?
Aparticle with charge q on the negative x axis and a second particle with charge 2q on the positive...
Questions
question
Mathematics, 07.10.2021 08:30
question
Mathematics, 07.10.2021 08:30
question
English, 07.10.2021 08:30