Physics, 25.01.2020 05:31 bluebabyyy

Which equation was used by albert einstein to explain the photoelectric effect? [e = energy, h = planck’s constant, and v = frequency.]

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 18:10

Scientists use laser range-finding to measure the distance to the moon with great accuracy. a brief laser pulse is fired at the moon, then the time interval is measured until the "echo" is seen by a telescope. a laser beam spreads out as it travels because it diffracts through a circular exit as it leaves the laser. in order for the reflected light to be bright enough to detect, the laser spot on the moon must be no more than 1.0 km in diameter. staying within this diameter is accomplished by using a special large-diameter laser. part a if λ = 540nm , what is the minimum diameter of the circular opening from which the laser beam emerges? the earth-moon distance is 384,000 km. express your answer to two significant figures and include the appropriate units.

Answers: 1

Answer

Physics, 21.06.2019 19:40

You carry a 7.0-kg bag of groceries 1.2 m above the ground at constant speed across a 2.7m room. how much work do you do on the bag in the process? (a) 157j (b) 0.00j (c) 185j (d) 82j

Answers: 2

Answer

Physics, 22.06.2019 01:20

Your target variable is δf, the magnitude of the difference in frequency between the waves emitted from the sonar device and the waves received by the device after reflecting off the whale. write an expression for δf in terms of the relevant frequencies using the subscript notation introduced above.

Answers: 3

Answer

Physics, 22.06.2019 02:50

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

Answer

You know the right answer?

Which equation was used by albert einstein to explain the photoelectric effect? [e = energy, h = pl...

Questions