subject
Physics, 24.01.2020 08:31 billy583887

Part one
a square plate is produced by welding together four smaller square plates, each of side
a. the weight of each of the four plates is
shown in the figure.
find the x-coordinate of the center of gravity (as a multiple of a).
answer in units of a.
(pictured)

part two
find the y-coordinate of the center of gravity
(as a multiple of a).
answer in units of a


Part one a square plate is produced by welding together four smaller square plates, each of si

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 13:00
Can you think of a way a rock unit with an older fossil could be above a rock until with a younger fossil? describe the scenario.
Answers: 2
question
Physics, 22.06.2019 13:00
Which of the following correctly describes what happens when an atomic bomb explodes? small pieces of fissionable material are joined and form a body with a mass greater than the critical mass, the relative number of neutrons escaping decreases, and a chain reaction and explosion result. large pieces of fissionable matter are brought together quickly and form a body with a mass smaller than the critical mass, the relative number of escaping neutrons increases, and a chain reaction and explosion result.
Answers: 2
question
Physics, 22.06.2019 22:00
If anyonee has done the momentum lab practical in physics can you give me the answers i am s lostt rnn : (
Answers: 2
question
Physics, 22.06.2019 22:30
Asailboat is traveling to the right when a gust of wind causes the boat to accelerate leftward at 2.5m/s2 for 4s. after the wind stops, the sailboat is traveling to the left with a velocity of 3.0m/s.assuming the acceleration from the wind is constant, what was the initial velocity of the sailboat before the gust of wind? answer using a coordinate system where rightward is positive.
Answers: 1
You know the right answer?
Part one
a square plate is produced by welding together four smaller square plates, each of si...
Questions
question
Mathematics, 03.08.2019 05:10