Physics, 06.12.2019 21:31 angelb2472

Aperson opens a 2-liter bottle of cola at a picnic. if the cap is left off the bottle, the cola will become 'flat' or lose it's carbonation. which statement below best summarizes why the cap must be kept tightly in place if the cola is to remain fresh?
a) the cap prevents the liquid in the cola from evaporating.
b) the cap keeps the atmospheric gases and liquid from mixing in the bottle.
c) the cap keeps warm air from entering the two-liter bottle and raising the temperature of the cola solution.
d) the cap keeps the pressure of the gas in the bottle at a high level preventing carbon dioxide from leaving the solution.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 05:30

What tightening torque should be used for a hexagonal head screw (not split-bolt) on a 250 kcmil conductor?

Answers: 3

Answer

Physics, 22.06.2019 16:00

Amichelson interferometer operating at a 600 nm wavelength has a 3.02-cm-long glass cell in one arm. to begin, the air is pumped out of the cell and mirror m2 is adjusted to produce a bright spot at the center of the interference pattern. then a valve is opened and air is slowly admitted into the cell. the index of refraction of air at 1.00 atm pressure is 1.00028.how many bright-dark-bright fringe shifts are observed as the cell fills with air?

Answers: 1

Answer

Physics, 22.06.2019 20:30

Aball is thrown from the top of a building with an initial velocity of 21.9 m/s straight upward, at an initial height of 51.6 m above the ground. the ball just misses the edge of the roof on its way down, as shown in the figure. (a) determine the time needed for the ball to reach its maximum height. (b) determine the maximum height. (c) determine the time needed for the ball to return to the height from which it was thrown, and the velocity of the ball at that instant. (d) determine the time needed for the ball to reach the ground. (e) determine the velocity and position of the ball at t = 5.35 s.

Answers: 1

Answer

Physics, 22.06.2019 21:40

Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.

Answers: 1

Answer

You know the right answer?

Aperson opens a 2-liter bottle of cola at a picnic. if the cap is left off the bottle, the cola will...

Questions