Amarble of mass m rolls with initial speed v down a long, horizontal hallway. eventually, the marble comes to a stop. how much work has friction performed on the marble?

-mv2

mv2

0.5mv2

-0.5mv2

Explanation:

Given:

Mass of marble =

Initial velocity of marble =

Final velocity of marble = 0 as it comes to rest.

By work energy theorem:

Work done by forces acting on marble is given by :

Work done = Final Kinetic energy - Initial Kinetic energy

Kinetic energy can be calculate using formula:

where represents mass of body and represents velocity of body.

Final kinetic energy:

Initial kinetic energy

Work done by friction on the marble

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

b.

explanation:

10.0