Aboat produced water waves of frequency 4 hz and wavelength 2m, if it reached the shore after 2 seconds how far is the boat from the shore?

S = 16 m

Explanation:

Given that

The frequency of the water waves, f = 4 Hz

The wavelength of the water waves, λ = 2 m

The time the waves reached the shore, t = 2 s

The relation between the velocity, wavelength, and the frequency of the wave is given by the relation,

                                           v = f λ    m/s

Substituting the given values in the above equation,

                                           v = 4 x 2

                                              = 8 m/s

The velocity of the water waves is v = 8 m/s

The distance between the shore and boat is given by

                                            s = v x t

                                               = 8 x 2

                                               = 16 m

Hence, the distance between the boat and the shore is, s = 16 m

this allows people to make the best decision or pursue the best option. when alternatives are weighed using their advantages and disadvantages, the option whose disadvantages outweigh the advantages (based on a qualitative or quantitative analysis) are shunned while those whose advantages outweigh their disadvantages are pursued.  

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).