When an electron goes from a higher energy level back down to the ground state, what is the most accurate way to describe the light it emits? always a single photon, with less energy than the electron absorbed to move up to the higher level. the electron does not emit light but absorbs light. one or more photons, always with less total energy than the energy the electron absorbed to move up to the higher level. always a single photon, equal in energy to the energy the electron absorbed to move up to the higher level. one or more photons, equal in total energy to the energy the electron absorbed to move up to the higher level.

Suppose water is leaking from a tank through a circular hole of area ah at its bottom. when water leaks through a hole, friction and contraction of the stream near the hole reduce the volume of water leaving the tank per second to cah 2gh , where c (0 < c < 1) is an empirical constant. a tank in the form of a right-circular cone standing on end, vertex down, is leaking water through a circular hole in its bottom. (assume the removed apex of the cone is of negligible height and volume.) (a) suppose the tank is 20 feet high and has radius 8 feet and the circular hole has radius 2 inches. the differential equation governing the height h in feet of water leaking from a tank after t seconds is dh dt = − 5 6h3/2 . if the height of the water is initially 8 feet, how long will it take the tank to empty? (round your answer to two decimal places.)

Which lists the fundamental forces in order, from strongest to weakest? strong nuclear, weak nuclear, electromagnetic, gravitational strong nuclear, electromagnetic, weak nuclear, gravitational gravitational, weak nuclear, electromagnetic, strong nuclear electromagnetic, gravitational, strong nuclear, weak nuclear

At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.