Place the following steps in order for motor control. 1. upper motor neurons stimulate lower motor neurons. 2. sensory information is relayed back to the cerebellum so movement can be modified if needed. 3. upper motor neurons in the premotor cortex select a motor program. 4. lower motor neurons stimulate a skeletal muscle to contract. 5. the basal nuclei enable the thalamus to stimulate upper motor neurons of the primary cortex.

3, 5, 1, 4, 2

Explanation:

When the body needs to move, certain muscles need to be stimulated in order to perform a certain movement. There is a process that is followed that starts with the brain sending a signal, and ends with the movement being performed by the body.

3. This is the first step, because a pathway needs to be established before any electric impulses can be sent. Hence, the upper motor neurons in the premotor cortex need to choose a pathway (known as a motor program).

5. This is the second step, because once a pathway has been established, a signal needs to be sent down that pathway. Hence, the basal nuclei enable the thalamus to stimulate the upper motor neurons to send an electrical impulse down the pathway.

1. This is the third step, because once the upper motor neurons have been stimulated, they send an electrical impulse to stimulate the lower motor neurons.

4. This is the forth step, because once the electrical impulse reaches the lower motor neurons, they pass the impulse to a certain group of skeletal muscles, causing them to contract.

2. This is the final step, because once the skeletal muscles have contracted, the body has completed its movement. However, once the body has moved, sensory information is relayed to the cerebellum to ensure that the correct movement is made, and if it needs to be adjusted, then the whole process will start again in order to correct the movement.

  1.the balanced   chemical equation is as below

cu +   2 ag(no)₃ → cu(no₃)₂   +2 ag

2.the   much silver   produced   is   50.9 g

step 1: find the   moles of cu

moles =   mass÷   molar mass

  from periodic table the molar mass of cu = 63.5 g/mol

moles is therefore = 15.00 g÷ 63.5 g/mol = 0.236   moles

step 2: use the mole ratio to determine the   moles of ag

from equation above   cu: ag   is 1: 2

therefore the moles of ag   =0.236   moles   x 2/1 =0.472   moles

step 3: find the mass   of ag

mass = moles x molar mass

from periodic table   the molar mass of ag =107.87 g/mol

mass   = 0.472   moles x 107.87 g/mol = 50.9 g

3.   the   much   silver   collected worth is   1.797 oz

  convert   50.9 g   to oz

that is   1 gram = 0.0353 oz

          50.9 grams =?   oz

by cross multiplication

={(50.9 grams x 0.0353 oz) / 1   gram}   =1.797 oz