Physics, 18.07.2019 22:30 samsamisam4951

The equation of a transverse wave is given by: y(x, t)-3sin(kx 10t) both x and y are expressed in meters and t is expressed in seconds. the value of k is positive. (a) find the value of the frequency, the amplitude of the wave and the direction of the wave. (4 marks) (3 marks) the maximum transverse velocity? (3 marks) produce a standing wave. (1 marks) terms of a sine component which does not depend on ω and a cosine cornponent (b) it is known that the wave speed is 5 m/s. calculate the value of k and the wavelength. (c) calculate the transverse velocity of the above wave as a function of x and t. what is (d) write down the equation of a second wave, when added to the wave above, would (e) using the identity sin a+ sin b 2 sin(4+8) cos(a-8), express the standi which does not depend on k. (2 marks) () using the result in (e), determine the location of the nodes and antinodes in the standing wave.

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 23:30

Around faucet handle is part of a(n) a. lever b. screw c. inclined plane d. wheel and axle

Answers: 1

Answer

Physics, 22.06.2019 09:30

1. how to locate the image in converging(concave) mirror and diverging (convex) mirror with salt. 2. how to locate the image in a converging (convex) lens and diverging (concave) lens with salt.

Answers: 1

Answer

Physics, 22.06.2019 10:50

Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.

Answers: 3

Answer

Physics, 22.06.2019 12:30

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

Answer

You know the right answer?

The equation of a transverse wave is given by: y(x, t)-3sin(kx 10t) both x and y are expressed in m...

Questions