Physics, 28.01.2020 22:09 bxbykay1

Aglass pipe system has a very corrosive liquid flowing in it (think hydrofluoric acid, say). the liquid will destroy flow meters, but you need to know the flow rate. one way of measuring the flow rate is to add a fluorescent dye to the liquid at a known concentration, and then downstream activate the dye by uv light and then measure the dye concentration by emitted light. if the dye is added at 1.00 g/s, and the dye concentration downstream is 0.050% by mass, what is the unknown flow rate in kg/h

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 21:50

When applying kirchhoff's rules, one of the essential steps is to mark each resistor with plus and minus signs to label how the electric potential changes from one end of the resistor to the other. the circuit in the drawing contains four resistors, each marked with the associated plus and minus signs. however, one resistor is marked incorrectly. which one is it?

Answers: 1

Answer

Physics, 21.06.2019 22:50

Acar of mass m goes around a banked curve of radius r with speed v. if the road is frictionless due to ice, the car can still negotiate the curve if the horizontal component of the normal force on the car from the road is equal in magnitude to 101) a) mv2/r b) mg/2. d) mg e) tan[v2/(eg)]

Answers: 2

Answer

Physics, 21.06.2019 23:00

The key to stability is feedback between the reservoir and the fluxes into and/or out of the reservoir. assume that the rate of outflow from a reservoir depends on the size of the reservoir according to the following relationship: outflow rate= k x (size of reservoir), where k is a constant. a reservoir of water has a volume of 5000 liters, and the rate of outflow at steady state is 25 liters per minute. what is k? (give both the numerical value and its units.) what is the residence time? what is the relationship between k and the residence time?

Answers: 1

Answer

Physics, 22.06.2019 16:00

Amichelson interferometer operating at a 600 nm wavelength has a 3.02-cm-long glass cell in one arm. to begin, the air is pumped out of the cell and mirror m2 is adjusted to produce a bright spot at the center of the interference pattern. then a valve is opened and air is slowly admitted into the cell. the index of refraction of air at 1.00 atm pressure is 1.00028.how many bright-dark-bright fringe shifts are observed as the cell fills with air?

Answers: 1

Answer

You know the right answer?

Aglass pipe system has a very corrosive liquid flowing in it (think hydrofluoric acid, say). the liq...

Questions