subject
Physics, 27.06.2019 05:00 Shyerica

The molar mass of a gas you can pick more than one a. is independent of the type of gas b. can be found easily from the periodic table c. is dependent on the temperature d. is the mass of a mole of the gas

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 22:00
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
question
Physics, 22.06.2019 00:00
Name three different units of energy used to measure heat and describe what type of situations each is usually used.
Answers: 1
question
Physics, 22.06.2019 10:50
The temperature at a point (x, y) is t(x, y), measured in degrees celsius. a bug crawls so that its position after t seconds is given by x = 6 + t , y = 8 + 1 3 t, where x and y are measured in centimeters. the temperature function satisfies tx(3, 9) = 5 and ty(3, 9) = 4. how fast is the temperature rising on the bug's path after 3 seconds? (round your answer to two decimal places.)
Answers: 3
question
Physics, 22.06.2019 18:10
Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)
Answers: 1
You know the right answer?
The molar mass of a gas you can pick more than one a. is independent of the type of gas b. can be...
Questions
question
English, 04.01.2021 16:50
question
Mathematics, 04.01.2021 17:00
question
SAT, 04.01.2021 17:00