Aguitar string with a length of 80.0 cm is plucked. the speed of a wave in the string is 400 m/sec. calculate the frequency of the first, second, and third harmonics.

Date chapter motion and speed review part a. vocabulary review directions: write the terms that match each description below in thes complete the sentence in number 13. ich each description below in the spaces provided. the boxed letters will 1. equal forces acting in opposite directions (2 words) 2. occurs when an object's velocity decreases (2 words) 3. sum of all forces acting on an object (2 words) 4. total distance divided by total time (2 words) 5. name for the slant of a line on a graph 6. distance divided by time 7. a push or a pull exerted on a body or object 8. distance and direction of an object from its starting point 9. tendency to resist change in motion 10. measure of how far an object has moved 11. speed and direction of motion 12. rate of change of position at a specific point in time (2 words) 13. the rate of change in velocity is called motion and spe

Current 1 of 8.4 a runs for 240 seconds and then stops. current 2 is 10.5 a. how long does current 2 have to un to deliver the same amount of charge as current 1? 88.28 192 s 2016 s 21,000 s

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.