Afluid in an aquifer is 23.6 m above a reference datum, the fluid pressure (in gage pressure) is 4390 n/m2 and the flow velocity is 7.22 x 10-4 m/s. the fluid density is 0.999 x 103 kg/m3. using the bernoulli relationship (including velocity), calculate the (a) total energy per unit mass, and (b) total energy per unit weight. report your answer in units of meters and seconds. assume that g = 9.8 m/s2.

As per Bernuolli's Theorem total energy per unit mass is given as

now from above equation

now by above equation

Part B)

Now energy per unit weight

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the answer is 100. i just did this lesson and got a 100% on it. : )

-fishtank