Physics, 14.07.2019 22:00 marlenerojas201

What is the acceleration of a cabinet of mass 45 kg if jake and ted push it by applying horizontal force of 25 newtons and 18 newtons respectively in the same direction

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 03:50

The intensity of a polarized electromagnetic wave is 12 w/m^2. part a) what will be the intensity after passing through a polarizing filter whose axis makes the angle θ=0∘ with the plane of polarization? part b) what will be the intensity after passing through a polarizing filter whose axis makes the angle θ=30∘ with the plane of polarization? part c) what will be the intensity after passing through a polarizing filter whose axis makes the angle θ=45∘ with the plane of polarization? part d) what will be the intensity after passing through a polarizing filter whose axis makes the angle θ=60∘ with the plane of polarization? part e) what will be the intensity after passing through a polarizing filter whose axis makes the angle θ=90∘ with the plane of polarization?

Answers: 1

Answer

Physics, 22.06.2019 05:20

Very large accelerations can injure the body, especially if they last for a considerable length of time. one model used to gauge the likelihood of injury is the severity index ( ), defined as =/ . in the expression, is the duration of the accleration, but is not equal to the acceleration. rather, is a dimensionless constant that = the number of multiples of that the acceleration is equal to.in one set of studies of rear-end collisions, a person's velocity increases by 13.7 km/h with an acceleration of 36.0 m/s2 . let the + direction point in the direction the car is traveling. what is the severity index for the collision?

Answers: 1

Answer

Physics, 22.06.2019 10:30

Agroup of students were investigating the force of gravity. they began by dropping a foam ball from a height of 3 meters into a bucket of sand. the ball hit the sand in 0.306 seconds. they dropped additional balls of approximately the same diameter, but of different masses. here is the data they collected. based on this experiment and the collected data, what would their conclusion be?

Answers: 1

Answer

Physics, 22.06.2019 15:30

At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.

Answers: 1

Answer

You know the right answer?

What is the acceleration of a cabinet of mass 45 kg if jake and ted push it by applying horizontal f...

Questions