subject
Physics, 15.07.2019 22:30 lexiremmickp6mlxe

The input torque on the shaft is 5 pound-feet and the output torque is 10 pound-feet. what’s the torque ratio? a. 4: 1 b. 1: 1 c. 3: 1 d. 2: 1

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 19:00
Ahorizontal force of 400.0 n is required to pull a 1760 n truck across the floor at a constant speed. find the coefficient of sliding friction.
Answers: 1
question
Physics, 22.06.2019 23:30
You have two photos of a person walking. one shows the person at the corner of third and main streets, the other shows the person at the corner of tenth and main streets. there are lampposts at every corner in this town, and the first picture shows it to be 10: 32: 00 exactly. the second picture shows it to be 10: 49: 30. you know three facts: (1) all of the clocks are synchronized; (2) there are exactly 12 equal-sized blocks per kilometer in this town; and (3) the streets that cross main in this area are numbered consecutively, with no interruptions. what is the person’s average speed in kilometers per hour?
Answers: 2
question
Physics, 23.06.2019 03:10
You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.
Answers: 2
question
Physics, 23.06.2019 06:30
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
You know the right answer?
The input torque on the shaft is 5 pound-feet and the output torque is 10 pound-feet. what’s the tor...
Questions
question
Mathematics, 01.09.2021 19:20
question
History, 01.09.2021 19:20
question
History, 01.09.2021 19:20