Mathematics, 15.12.2021 18:30 aylagwilliamson

DO NOT DELETE The x-coordinate is the station number, and the y-coordinate is the time in minutes since the start of the race that she completed the task.

(1, 2), (2, 4), (3, 8), (4, 16)

Part A: Is this data modeling an arithmetic sequence or a geometric sequence? Explain your answer. (2 points)

Part B: Use a recursive formula to determine the time she will complete station 5. Show your work. (4 points)

Part C: Use an explicit formula to find the time she will complete the 10th station. Show your work. (4 points)

Answers: 2

Show answers

Another question on Mathematics

Mathematics, 21.06.2019 14:30

Sadie computes the perimeter of a rectangle by adding the length, l, and width, w, and doubling this sum. eric computes the perimeter of a rectangle by doubling the length, l, doubling the width, w, and adding the doubled amounts. write an equation for sadie’s way of calculating the

Answers: 3

Answer

Mathematics, 21.06.2019 15:30

The ratio pv to nrt is plotted against pressure for ch4 at 0°c and 200°c. why does the curve for 0°c drop below the horizontal line for an ideal gas whereas the curve for 200°c does not?

Answers: 2

Answer

Mathematics, 21.06.2019 19:00

Candy lives in the center of town. her friend darlene lives 28 miles to the east and her friend dana lives 21 miles north. approximately how far do dana and darline live apart ?

Answers: 1

Answer

Mathematics, 21.06.2019 22:00

Arefrigeration system at your company uses temperature sensors fixed to read celsius (°c) values, but the system operators in your control room understand only the fahrenheit scale. you have been asked to make a fahrenheit (°f) label for the high temperature alarm, which is set to ring whenever the system temperature rises above –10°c. what fahrenheit value should you write on the label?

Answers: 3

Answer

You know the right answer?

DO NOT DELETE The x-coordinate is the station number, and the y-coordinate is the time in minutes...

Questions

Engineering, 23.11.2020 04:00

4. Set the height of the cutting tool tip a. against the workplace. b. at the center of the workpiece. c. slightly above the center of th...