subject

Mathematics, 23.11.2021 15:00 mckinzirauch9

What is the answer for this Which statement is NOT true for the graph shown? Select all that apply

The point (0,0) represents the beginning of the trip

The unit rate is 0 miles per hour

The relationship between time and distance is directly proportional

The point (3, 165) means the car traveled 3 miles in 165 minutes

It takes more time to drive 220 miles than to drive 275 miles

The constant of proportionality represents distance/time

What is the answer for this

Which statement is NOT true for the graph shown? Select all that appl

ansver

Answers: 1

Show answers

Another question on Mathematics

question

Mathematics, 21.06.2019 15:00

Answer this question! 30 points and brainliest! only if you know the answer.

Answers: 1

question

Mathematics, 21.06.2019 18:00

Adj has a total of 1075 dance and rock songs on her system. the dance selection is 4 times the size of the rock selection. write a system of equations to represent the situation.

Answers: 1

question

Mathematics, 21.06.2019 19:30

You deposit $5000 each year into an account earning 3% interest compounded annually. how much will you have in the account in 30 years?

Answers: 3

question

Mathematics, 21.06.2019 23:30

Answer each of the questions for the following diagram: 1. what type of angles are these? 2. solve for x. what does x equal? 3. what is the measure of the angles?

Answers: 1

You know the right answer?

What is the answer for this Which statement is NOT true for the graph shown? Select all that apply...

Questions

question

Engineering, 11.07.2019 05:10

Acylindrical specimen of some metal alloy having an elastic modulus of 117 gpa and an original cross-sectional diameter of 3.6 mm will experience only...

question

Engineering, 11.07.2019 05:10

Arigid, insulated tank that is initially evacuated is connected through a valve to a supply line that carries steam at 3.5 mpa. now the valve is opene...

question

Engineering, 11.07.2019 05:10

Aheat pump, using ammonia as the refrigerant, has the following conditions , heat effect 75,000kj/sec , evaporator pressure 0.22mpa , condenser pressu...

question

Engineering, 11.07.2019 05:10

A2.5 cm diameter horizontal water jet with a speed of vi- 40 m/s relative to the ground is deflected by a 60° stationary cone whose base diameter is 2...

question

Engineering, 11.07.2019 05:10

For a specified inlet state, exit pressure and mass flowrate, the power input of a that of an compressor operating adiabatically and at steady state w...

question

Engineering, 11.07.2019 05:10

Asingle-cylinder four-stroke-cycle spark- ignition engine has a bsfc of 0.4 kg/kw-hr and a volumetric efficiency of 78% at a speed of 45 rps. the bore...

question

Engineering, 11.07.2019 05:10

Heat in the amount of 100 kj is transferred directly from a hot reservoir at 1200 k to a cold reservoir at 600k. calculate the entropy change of the t...

question

Engineering, 11.07.2019 05:10

A1m by 1m square gate is to be located on one vertical side of a tank that will contain 2 m depth of water up to the bottom of the gate. determine the...

question

Engineering, 11.07.2019 05:10

Acylindrical metal specimen having an original diameter of 11.80 mm and gauge length of 51.7 mm is pulled in tension until fracture occurs. the diamet...

question

Engineering, 11.07.2019 05:10

Air is compressed in an isentropic process from an initial pressure and temperature of p1 = 90 kpa and t1=22°c to a final pressure of p2=900 kpa. dete...

question

Engineering, 11.07.2019 05:10

Is a process that is internally reversible and adiabatic necessarily isentropic? explain using an equation....

question

Engineering, 11.07.2019 05:10

After the formation of cells is finished, a cellular manufacturing system can use either a decoupling or an integrating approach to manage the materia...

question

Engineering, 11.07.2019 05:10

Apipe system consists of a lower section with two 90° elbows and an upper section with a 180° bend and two straight flow tees. if the flow is measured...

question

Physics, 11.07.2019 05:10

Asled of mass m is being pulled horizontally by a constant horizontal force of magnitude f. the coefficient of kinetic friction is μk. during time int...

question

Engineering, 11.07.2019 05:10

What is analogous to the convection coefficient in structural analysis? (1)-prescribed displacement (2)-prescribed stress (3)-damping coeffcient (4)-...

question

Engineering, 11.07.2019 05:10

What is the prestress load that results in making the first natural frequency of a column goes to zero? (1)yield stress (2) second buckling load (3)...

question

Biology, 11.07.2019 05:10

Transcription initiation of the lac operon is enhanced when interacts with rna polymerase....

question

Mathematics, 11.07.2019 05:10

Which linear function represents the line given by the point-slope equation y + 7 = –(x + 6)? f(x) = –x – 11 f(x) = –x – 1 f(x) = –x + 3 f(x) = –x +...

question

Social Studies, 11.07.2019 05:10

What is the proper way to use a fire extinguisher?...

question

Mathematics, 11.07.2019 05:10

The largest possible circle is cut out of a square whose side length is 6 feet. what will be the approximate area, in square feet, of the remaining bo...

More questions: Mathematics Another questions