Furniture and fixtures cost $20,000. Expected life for these assets is 5 years and the estimated salvage value is $5,000. Calculate the annual
depreciation charge (D) using the straight line method. *

median is the value separating the higher half of a data sample, a population or probablity distribution from the lower half.

step-by-step explanation:

say you have 3,8,7,3,1,9,8 order them from lowest to highest

if orderd it would be 1,3,3,7,8,8,9 now you take away from the lowest and the highest until you end up in the middle.

so you would remove the 1 and 9 leaving you with 5 digits remaining

when you've reached the middle that would be your answer so in this case the answer is 7

if there were two numbers left say 7 and 5 you'd and them together so 12 then divide by 2 witch would equal 6 so the answer would be 6

good luck on that project hoped i you at all

2 & 7

step-by-step explanation:

he climbs 300 ft/hr at a constant rate. the peak is at 1,500 ft.

when going up, he reaches 600 ft in 2 hours. remember, that he is going in a constant rate. divide 600 with 300:

600/300 = 2

assuming that he takes the same route back (meaning that it's a 1500 ft route back, you can solve.

note also that you are solving when he gets back to 600 ft after he reaches the peak.

first, find the amount of hours it takes to get up the peak. divide the total amount (1500), with the ft/her (300) to get the amount of hours (x):

1500/300 = x

x = 5

it takes jamie 5 hours to get up. now, he is returning down, and reaches 600 (his current destination). remember that he climbs at a constant 300 ft/hr. divide 600 with 300:

600/300 = x

x = 2

now add the two numbers together.

x = 5 + 2 = 7

jamie takes 7 hours to go up the mountain and reach his current position when descending.

(total amount/constant rate) = (time).

remember that it is a constant rate, so in total, when he gets back down the mountain, it will take the same amount of time as when he goes up. the total amount for the round trip is: 5 + 5 = 10.

~

13cm

step-by-step explanation:

(apex)

x=0

step-by-step explanation: