The diameter of a metal shaft used in a disk-drive unit is normally distributed with mean 0.2508 in. and std. dev. 0.0005 in. The specification on the shaft have been established as (0.25-0.0015 in, 0.25 0.0015in) If the process mean has been adjusted to 0.25 in, what fraction of the shafts produced does NOT conform to specifications

i'm not entirely sure

step-by-step explanation:

if you ask home depot or lowe's they might be able to you out

9

step-by-step explanation:

(-5,-28)

i graphed to on desmos.

b

step-by-step explanation:

the equation of a line in point- slope form is

y - b = m(x - a)

where m is the slope and (a, b) a point on the line

calculate m using the slope formula

m = (y₂ - y₁ ) / (x₂ - x₁ )

with (x₁, y₁ ) = (0, 4) and (x₂, y₂ ) = (3, - 5) ← 2 points on the line

m = = = - 3

with m = - 3 and (a, b) = (3, - 5), then

y - (- 5) = - 3(x - 3), that is

y + 5 = - 3(x - 3) → b