Mathematics, 09.12.2020 02:30 zivicion

Engineering: Tolerance is an allowance made for imperfection in a manufactured object. The manufacturer of an oven specifies a temperature tolerance of 15 degrees Fahrenheit. This means that the temperature inside the oven will be within 15 degrees Fahrenheit to which it is set. Write an absolute value equation to represent the temperatures inside the oven when the thermostat is set to 400 degrees Fahrenheit.

Solve the equation to find the maximum and minimum temperatures inside the oven.

Answers: 1

Show answers

Another question on Mathematics

Mathematics, 21.06.2019 14:30

Restrictions on f(x) = 1/x+5 and g(x) = x-2

Answers: 1

Answer

Mathematics, 21.06.2019 19:30

Ascientist wants to use a model to present the results of his detailed scientific investigation. why would a model be useful? a )because the model makes the concepts easier to understand b) because the model is easy to put together and to use c) because the model prevents other scientists from asking questions d) because the model requires the audience to pay full attention to it i don't know what to choose because between a and d a is much more likely than d because it only wants to get the attention of the audience. i'm confuse.

Answers: 1

Answer

Mathematics, 21.06.2019 22:30

Which statements are true about additional information for proving that the triangles are congruent check all that apply

Answers: 1

Answer

Mathematics, 21.06.2019 23:40

Statement reason 1. δabc is similar to δced. given 2. 3. definition of slope 4. slope of slope of definition of slope 5. slope of × slope of multiplying the slopes 6. slope of × slope of substitution property of equality 7. slope of × slope of simplifying the right side the table contains the proof of the relationship between the slopes of two perpendicular lines. what is the reason for statement 2? a. parallel line segments that meet a common perpendicular line are proportional in length. b. the lengths of vertical and horizontal sides in congruent triangles are in a common ratio. c. trigonometric identities determine the lengths of the legs in a right triangle. d. corresponding side lengths in similar triangles are proportional in length.

Answers: 2

Answer

You know the right answer?

Engineering: Tolerance is an allowance made for imperfection in a manufactured object. The manufactu...

Questions

Mathematics, 03.12.2019 11:31

At her health club, elke likes to use exercise bikes and weights. she spent 3/4 hour on the bikes and 1/5 hour less than that on the weights. how much...

Mathematics, 03.12.2019 11:31

Jenny was planning a trip to the united arab emirates. before going, she did some research and learned that the exchange rate is 4 dirhams for every $...