Mathematics, 31.03.2020 00:07 ianbrown00121
The diameters of bolts produced in a machine shop are normally distributed with a mean of 5.725.72 millimeters and a standard deviation of 0.070.07 millimeters. Find the two diameters that separate the top 5%5% and the bottom 5%5%. These diameters could serve as limits used to identify which bolts should be rejected. Round your answer to the nearest hundredth, if necessary.
Answers: 3
Mathematics, 21.06.2019 19:30
It is saturday morning and jeremy has discovered he has a leak coming from the water heater in his attic. since plumbers charge extra to come out on the weekends, jeremy is planning to use buckets to catch the dripping water. he places a bucket under the drip and steps outside to walk the dog. in half an hour the bucket is 1/5 of the way full. what is the rate at which the water is leaking per hour?
Answers: 1
Mathematics, 21.06.2019 22:30
Complete the equation of the live through (-1,6) (7,-2)
Answers: 1
Mathematics, 21.06.2019 22:30
Bob the builder is making 480kg of cement mix. this is made by cement, sand and gravel in the ratio 1: 3: 4
Answers: 3
Mathematics, 21.06.2019 23:00
The weight of a radioactive isotope was 96 grams at the start of an experiment. after one hour, the weight of the isotope was half of its initial weight. after two hours, the weight of the isotope was half of its weight the previous hour. if this pattern continues, which of the following graphs represents the weight of the radioactive isotope over time? a. graph w b. graph x c. graph y d. graph z
Answers: 2
The diameters of bolts produced in a machine shop are normally distributed with a mean of 5.725.72 m...
Physics, 18.11.2019 12:31
History, 18.11.2019 12:31
Mathematics, 18.11.2019 12:31
History, 18.11.2019 12:31