Total solidification times of three casting geometries are to be compared: (1) a sphere, (2) a cylinder, in which the length-to-diameter ratio = 1.0, and (3) a cube. volume = 1000 cm3 for all three shapes, and the same casting alloy is used. (a) determine the relative solidification times for each geometry. (b) based on the results of part (a), which geometric element would make the best riser? (c) if the mold constant = 3.5 min/cm2 in chvorinov's rule, compute the total solidification time for each casting.

2 & 7

step-by-step explanation:

he climbs 300 ft/hr at a constant rate. the peak is at 1,500 ft.

when going up, he reaches 600 ft in 2 hours. remember, that he is going in a constant rate. divide 600 with 300:

600/300 = 2

assuming that he takes the same route back (meaning that it's a 1500 ft route back, you can solve.

note also that you are solving when he gets back to 600 ft after he reaches the peak.

first, find the amount of hours it takes to get up the peak. divide the total amount (1500), with the ft/her (300) to get the amount of hours (x):

1500/300 = x

x = 5

it takes jamie 5 hours to get up. now, he is returning down, and reaches 600 (his current destination). remember that he climbs at a constant 300 ft/hr. divide 600 with 300:

600/300 = x

x = 2

now add the two numbers together.

x = 5 + 2 = 7

jamie takes 7 hours to go up the mountain and reach his current position when descending.

(total amount/constant rate) = (time).

remember that it is a constant rate, so in total, when he gets back down the mountain, it will take the same amount of time as when he goes up. the total amount for the round trip is: 5 + 5 = 10.

~

answer: 1inch=7days  

12inch=12*7=84days

step-by-step explanation:

if you get paid hourly because if you get a salary you could work all week and only get paid a certain amount no matter how much you work but if you get paid hourly then you get paid for every minute you worked.