You are preparing to park your car and you notice that you are near a railroad crossing. you must not park

True. Because it can cause damage to the dynamo engine and the wrapping of an already weak car can die suddenly. If this happens, get out of your car immediately, because the car engine will be difficult to start again.

Further Explanation

Rails are metal bars for railway runways or similar vehicles such as trams and so on. Train directions/guides without control. Rails are two rigid metal rods of the same length that are mounted on a bearing as a foundation. Rails are fastened to bearings using rail nails, fastening screws, or e fastening (such as fastening fasteners).

The type of binder used depends on the type of bearing used. Screw nails or fasteners are used on wooden bearings, while the "e" fastening screws are used for concrete or cement bearings.

The railroad track looks closer

Rails are usually installed on a road lined with stone or also known as ballast. Ballast function on the railroad to reduce vibration and rail arches due to the weight of the train. To cross a bridge, wooden pads that are more elastic than concrete bearings are used.

Rail type based on weight

The rails used in Indonesia use the UIC standard with the following standards:

Rail 25, which means that every 1 meter of the rail section weighs 25 kilograms (kg). Rail 33 Rail 41 Rail 42, which means that every 1 meter of the rail section weighs 42.59 kilograms Rail 50 Rail 54 which means that every 1-meter rail section weighs 54.43 kilograms Rail 60

The reason why the engine died on the rails

Technically, the locomotive has a boogie. Well, the main component is the dynamo. In the dynamo, there is also a fairly large magnetic element. If the CC series locomotive means 3 series of boogies (6 large dynamos). This, of course, has an impact on rails made of steel and can provide a magnetic field as far as one kilometer from the locomotive.

When a motorized vehicle crosses the railroad tracks (KA) usually uses a low speed, if the driver does not shift the lower engine gears, then the engine speed of the motor vehicle dynamo and the existing coil can immediately die because of the magnetic field factor boogie train sent by the train. Therefore JPL officers always close the crossing door before the train approaches the intersection (approximately Km). If a driver continues to break through or cross a railroad track that is less than one kilometer, it will definitely cause the dynamo engine and the weak coil of the car to die suddenly.

Learn more

Definition of Rails

Rail type based on weight

The reason why the engine died on the rails

Details

Grade: High School

Subject: Health

keywords: Rails

Can you give answer choices?

Maybe meditation,stress relievers,try to have quite time try to get school done on time and try to go to bed earlier