Engineering, 14.04.2022 06:10 jmackenzie7

A single packed bed reactor is to be designed to process 100 mol/s of reactant A so as to produce product R. Feed gas at 2.49 MPa and 300 K, the allowable Tmax = 900 K, unless otherwise noted, Tmin= 300 K, the product stream is wanted at 300 K, and the thermodynamics and kinetics of the exothermic reaction are given to us in Fig. 19.11. Prepare a sketch of your recommended design and on it show a .The flow arrangement selected: plug, or mixed flow reactor b. Weight of catalyst needed
c. Heat duty ahead of the reactor, at the reactor itself, and after the reactor
d. Temperature of all flowing streams Work out a good design for 80% conversion of a feed consisting of 1 mole A and 7 moles of inert, with Cp = 40 J/mol. K

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

You know the right answer?

A single packed bed reactor is to be designed to process 100 mol/s of reactant A so as to produce pr...

Questions