subject
Engineering, 24.01.2022 03:30 penacesar18p9jrdh

I'm I. I. . I. . I. I. I'll. . . You. We are. Can. I. . . I. I'll be. I. I am. I. I. . I have. I. We are going. I have. We. . I'll. . We be. I have. . . You can you. Can you do. I. I. . I. I. I. I'll. I. I. I'll. We. We are. I. I. . . . . I have all. . . I. I'll. We. . . Can. . I. I have. I. . I. I. I. . . I. . I have to. . . I have. I. . I. I. . . . I. . . I have. I just. I. I. I. I. I have. . I. . . I. I. I. I. I. . . I. I have to. I. . I have to go. I. I'll be. . I. . I. I. I. I. I. . I have. I. . I. . . I. . . . I. I have to. . I have. I have. . . I have to. I. I have. I have to. . . . I. . I. I have. I'll. I have. We are going. We are. . You. . . . . I lÀ

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
I'm I. I. . I. . I. I. I'll. . . You. We are. Can. I. . . I. I'll be. I. I am. I. I. . I have. I. We...
Questions
question
Chemistry, 23.10.2020 22:30
question
Mathematics, 23.10.2020 22:30
question
Mathematics, 23.10.2020 22:30