Engineering, 23.12.2021 03:30 2022rickskyye

The sketch shows a test set-up for measuring the thrust of a liquid oxygen-liquid alcohol rocket. The alcohol and oxygen enter at section 1 with a velocity of 15 m/sec, at a pressure of 50 atm, and with a mass rate of flow of 5 kg/sec. The inlet pipe for the alcohol and oxygen is very flexible, so that the force it exerts on the combustion chamber is negligible. In the exit place of the jet nozzle, at section 2, it is known that the pressure is 2 atm and the exit-plane area is 65 cm2. The force exerted on the scale at the left when the silencer is not used is 1800 N. Atmospheric pressure is 100 kPa.
Estimate the jet velocity in the exit plane of the nozzle when the silencer is not used.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

The sketch shows a test set-up for measuring the thrust of a liquid oxygen-liquid alcohol rocket. Th...

Questions