subject
Engineering, 22.12.2021 16:40 coontcakes

9.4. An unconfined aquifer with a specific yield of 0.20 is used as a water supply for the ir- rigation of farm land. The recharge area of the aquifer is the same area as the irri- gated area. The recharge is limited to 76 mm (3.0 in.) per year. The saturated thick- ness of the aquifer is 15.2 m (50ft). How many years will the water supply last if 254 mm (10.0 in.) of water per year is pumped from the aquifer for irrigation

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
You know the right answer?
9.4. An unconfined aquifer with a specific yield of 0.20 is used as a water supply for the ir- rigat...
Questions
question
Mathematics, 10.01.2022 14:00
question
Mathematics, 10.01.2022 14:00
question
Mathematics, 10.01.2022 14:00
question
Mathematics, 10.01.2022 14:00