subject
Engineering, 10.12.2021 21:10 nihadsalim10

XYZ Corporation permits its employees to borrow company tools. Engineer Al House took full advantage of this privilege. He went one step further and ordered tools for his unit that would be useful for his home building projects even though they were of no significant use to his unit at XYZ. Engineer Stacy Green had suspected for some time that Al was ordering tools for personal rather than company use, but she had no unambiguous evidence until she overheard a revealing conversation between Al and Gina Deal, a contract salesman from whom Al frequently purchased tools.
Stacy was reluctant to directly confront Al. They had never gotten along well, and Al was a senior engineer who wielded a great deal of power over Stacy in their unit. Stacy was also reluctant to discuss the matter with the chief engineer of their unit, in whom she had little confidence or trust Eventually Stacy decided to talk with the Contract Procurement Agent, whose immediate response was, "This really stinks." The Contract Procurement Agent agreed not to reveal that Stacy had talked with him. He then called the chief engineer, indicating only that a reliable source had informed him about Al House's inappropriate purchases. In turn, the chief engineer confronted Al. Finally, Al House directly confronted each of the engineers in his unit he thought might have "ratted" on him. When Al questioned Stacy, she denied any knowledge of what took place. Later Stacy explained to her partner, "I was forced to lie. I told Al, 'I don't know anything about this." List and discuss at least 5 ethical issues this case raises.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
XYZ Corporation permits its employees to borrow company tools. Engineer Al House took full advantage...
Questions
question
Social Studies, 04.03.2021 18:10
question
English, 04.03.2021 18:10
question
Mathematics, 04.03.2021 18:10