Engineering, 05.12.2021 17:20 saniyawilliams1207

Heat is being transferred from water to air through a brass wall having thermal conductivity of 75 W/mK. The size of brass wall is 0.5 m x 0.5 m. The mean temperature of wall and air are 90C and 30C, respectively. It is desired to increase the heat transfer rate by adding rectangular brass fins 1 mm thick, 25 mm in length and pitched 10 mm apart (center to center). Convective heat transfer coefficient between the wall and the air is 15 W/m2 K. a. Calculate the increase in the heat transfer from the wall as a result of adding fins.
neglect heat loss from the tip.
b. Determine the overall effectiveness of the fins.

Heat is being transferred from water to air through a brass wall having thermal conductivity of 75

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

Heat is being transferred from water to air through a brass wall having thermal conductivity of 75 W...

Questions