Engineering, 04.12.2021 01:10 myg21
Compute and tabulate station elevations for an equal-tangent parabolic curve given as: a 4.5% grade meets a 1.50% grade at station 4 200 and elevation 605.568 m, 180-m curve, stakeout at 30-m increments
Answers: 2
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Compute and tabulate station elevations for an equal-tangent parabolic curve given as: a 4.5% grade...
Mathematics, 29.04.2021 19:30
Chemistry, 29.04.2021 19:30
English, 29.04.2021 19:30
Mathematics, 29.04.2021 19:30
Mathematics, 29.04.2021 19:30
Physics, 29.04.2021 19:30
Chemistry, 29.04.2021 19:30
Mathematics, 29.04.2021 19:30
Mathematics, 29.04.2021 19:30
Mathematics, 29.04.2021 19:30
Mathematics, 29.04.2021 19:30