Engineering, 29.11.2021 23:50 silviamgarcia

A single-phase,230V, flat twin and earth TPS copper cable is to be installed to supply to a new oven in a bakery. The installation conditions are: The voltage at the switchboard is 230V

The maximum permitted drop 2%.

The cable is route length is20metres

The cable is clipped direct (touching)

The load is 8 kW.

The ambient air temperature is 35 degrees

The conductor temperature is 75 degrees.

.(a)Calculate minimum size copper cable that can be used to supply the load.(turn over)

(b)Calculate minimum size copper cable that can be used to satisfy the volt drop requirements.

(c)State the minimum size copper cable that will satisfy the load and voltage drop requirements.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

A single-phase,230V, flat twin and earth TPS copper cable is to be installed to supply to a new oven...

Questions