Engineering, 26.11.2021 01:00 holman9308

Water flows through a horizontal pipe at a rate of 2.6 gal/s. The pipe consists of two sections of diameters 4 in. and 2 in. with a smooth reducing section. The pressure difference between the two pipe sections is measured by a mercury manometer. Neglecting frictional effects, determine the differential height of mercury between the two pipe sections. Take the densities of mercury and water as rhoHg = 847 lbm/ft3 and rhoW = 62.4 lbm/ft3. Horizontal bottle has nozzle at the right side. At the right side of nozzle, cylindrical horizontal shape is shown. The right arrow labelled as flow. The differential height of mercury between the two pipe sections is in.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

You know the right answer?

Water flows through a horizontal pipe at a rate of 2.6 gal/s. The pipe consists of two sections of d...

Questions