subject
Engineering, 06.11.2021 02:40 kelseeygee

* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature reading on a thermometer if they put the thermometer inside a mitten (see diagram A above). Both thermometers started at room temperature. Annika’s group obtained two thermometers and a mitten. They put one thermometer inside the mitten and the other thermometer on the table next to the mitten. An hour later they compared the readings on the two thermometers. The temperature inside the room remained the same during their experiment. The thermometer inside the mitten will have a lower temperature reading than the thermometer on the table because the mitten will conduct the cold air outside the thermometer. Both thermometers will have the same temperature reading because the mitten doesn’t generate additional heat. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will trap the warm air inside the mitten. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will insulate the thermometer.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 19:10
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
question
Engineering, 04.07.2019 19:10
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
You know the right answer?
* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature readin...
Questions
question
Mathematics, 26.03.2021 16:50
question
Mathematics, 26.03.2021 16:50
question
Mathematics, 26.03.2021 16:50