Engineering, 05.11.2021 03:00 kimberlyalonso6697
Design a single linear phase equiripple FIR filter with two stopbands, the first stopband is from 100 KHz to 200 KHz the second stopband is from 500 KHz to 700 KHz. Other frequencies outside theserangesare in the passband. The sample rateis2MHz. The filter should have more than 50 dB attenuation at the center of the stopbands. The passbands shall have no more than 0.1dB of ripple. Plot the magnitude of the frequency response in Matlab and include this in your answer as well as your working Matlab code.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
You know the right answer?
Design a single linear phase equiripple FIR filter with two stopbands, the first stopband is from 10...
Questions
Mathematics, 30.11.2020 16:50
Social Studies, 30.11.2020 16:50
Mathematics, 30.11.2020 16:50
Mathematics, 30.11.2020 16:50
Mathematics, 30.11.2020 16:50
History, 30.11.2020 16:50
