subject
Engineering, 27.10.2021 08:30 lllmmmaaaooo

The wall designer recommends the use of rounded 3/8-inch nominal maximum aggregate size for this wall. The dry rodded unit weight for the coarse aggregate is 115 pcf with a specific gravity of 2.78. The moisturecontent for coarse aggregate is measured at 0.35% and the fine aggregate moisture content is 8.4%. The coarse and fine aggregates have absorption percentage of 1.1% and 1.4% respectively. The aggregate provider will be limited in fine aggregate supply, only providing aggregates with a fineness modulus of 2.70 with a specific gravity of 2.64. Cement will be provided by a local plant providing type I-II cement with a specific gravity of 3.15. No cementitious materials are available at this time. Air entraining admixture is needed for this interior wall. Required:
a. Provide the product name and type
b. Provide the manufacturer's recommended dosage (oz/lb of cement or mL/lb of cement)
c. Provide the dosage recommended for this wall (oz/CY of concrete or mL/CY of concrete)

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
The wall designer recommends the use of rounded 3/8-inch nominal maximum aggregate size for this wal...
Questions
question
Mathematics, 23.11.2020 09:30
question
Mathematics, 23.11.2020 09:30
question
Mathematics, 23.11.2020 09:30
question
English, 23.11.2020 09:30
question
History, 23.11.2020 09:40