Engineering, 25.10.2021 19:20 cashmeout28

While keeping the presentation that you just listened in mind, it is expected of you to prepare a gamification project idea draft that could solve one of the issues that are given. Each one of you should only choose one topic. I EXPECT AT LEAST 4 PAGES.

1 – (Client: IETT, Target: Working and studying people who live in İstanbul and have to deal with the perils of public transportation daily)

We have a huge traffic problem at İstanbul! A small but deadly part of this situation is how crowded it gets if one wants to use mass transportation. Regarding this, you are expected to find a solution using gamification to the problem of getting in and out from those public transportation vehicles. You should choose one means of public transportation (such as the bus or metrobus) and create your idea around it. Don’t forget! The problem is about just how we get on the vehicle and get off from it!

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

While keeping the presentation that you just listened in mind, it is expected of you to prepare a ga...

Questions