Engineering, 25.10.2021 07:50 kamkam6200

Q3 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 18 3 0
P2 4 1 1
P3 2 5 2
P4 6 4 3
P5 10 2 30
For the set of processes directly above, draw a Gantt chart for the SJF (Shortest Job
First – Non-Preemptive) Scheduling Algorithm. With CS = 0.
a) For the set of processes directly above, calculate the throughput for the SJF
(Shortest Job First -Non-Preemptive) Scheduling Algorithm.
b) For the set of processes directly above, calculate the turnaround time for
the SJF (Shortest Job First- Non-Preemptive) Scheduling Algorithm.
c) For the set of processes directly above, calculate the average turnaround
time for the SJF (Shortest Job First Non-Preemptive) Scheduling Algorithm.
d) For the set of processes directly above, calculate the waiting time for the
SJF (Shortest Job First Non-Preemptive) Scheduling Algorithm.
e) For the set of processes directly above, calculate the average waiting
time for the SJF (Shortest Job First) Scheduling Algorithm.
f) What is the CPU Utilization for the system?
Q 4 : Repeat Q2 with CS=1

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

You know the right answer?

Q3 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 18 3 0
...

Questions