subject
Engineering, 19.10.2021 01:00 liamgreene90

A mixture of hexane isomers (hexanes) is used in a parts cleaning and degreasing operation. A portion of the used solvent is recycled for further use by the following process. Used cleaning solvent containing 84.7 wt% hexanes, 5.1 wt% soluble contaminants, and the remainder particulates, is first filtered to yield a cake that is 72.0 wt% particulates and the remainder hexanes and soluble contaminants. The ratio of hexanes to soluble contaminants is the same in the dirty hexanes, the filtrate, and the residual liquid in the filter cake. The filter cake is then sent to a cooker in which nearly all of the hexanes are evaporated and later condensed. The condensed hexanes are combined with the liquid filtrate and then recycled to the parts cleaning operation for reuse. The cooked filter cake is further processed off site. a. How many lbm of cooked filter cake are produced for every 100 lbm of dirty solvent processed?
b. What is the weight percent of soluble contaminants in the cooked filter cake?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?
Answers: 3
question
Engineering, 04.07.2019 19:10
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
You know the right answer?
A mixture of hexane isomers (hexanes) is used in a parts cleaning and degreasing operation. A portio...
Questions
question
Mathematics, 20.05.2021 21:10