Engineering, 07.10.2021 16:00 avi49

A combined cycle power plant has a net power output of 264 MW. Air enters the compressor of the Brayton cycle at 100 kPa and 17oC. The pressure ratio is 20, the turbine inlet temperature is 1620 K and the gases leaving the turbine are used to heat the steam of the Rankine cycle to 600oC and 6 MPa. The combustion gas leaves the heat exchanger (HRSG) at 400 K and the condenser pressure is 10 kPa. The isentropic efficiency of the compressor is 87%, the gas turbine isentropic efficiency is 90%, the steam turbine isentropic efficiency is 92% and the pump efficiency is 65%. The condenser sub-cools the water by 10oC (10oC less than the saturation temperature). Using variable specific heat analysis, determine

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

Answer

You know the right answer?

A combined cycle power plant has a net power output of 264 MW. Air enters the compressor of the Bray...

Questions