Engineering, 26.09.2021 14:30 tsvijay121

As a machine shop owner, you are asked to produce parts are per drawing shown below. The part is to be waterjet cut from Aluminum (Al-6061-T6, density= 2.7 g/cm3) 0.063" thick plate stock costing
$12/pound. Water jet machine runs at a constant cutting speed of 200 mm/min, at an operating cost
of S20/hr.
1) Find the coordinate point of vertexes A to T to be used for CNC waterjet cutting machine.
2) Estimate the material cost per part.
3) Estimate the machining cost per part.
Drawing: All dimensions in inch. CNC starting point is at A= (2,2). Vertical dash line indicates line
of mirror symmetry

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

As a machine shop owner, you are asked to produce parts are per drawing shown below. The part is t...

Questions