subject
Engineering, 13.09.2021 18:50 genesis0523

- Ô DU ns 1 How much does it cost the organization when the inspector travels from doo 1 to department H (through department A, C, E, G and F) 2 How much is the total distance (in meters) does the inspector travels from door 1 to department E (through department A, C, I, H, F and G) 3. From department A How much money will the company save if they move department Eto same location as department F? (Through department C, H, F and G) 4. From the door 1 How much money will the company save if they move department I to same location as department E? (Through departmen AC, E, G, F and H) 5. What is the total cost of the supervisor travelling from department A up until he comes back again to department A 6. If the total distance of the inspector traveling from door 1until he comes back to door 1, is reduced to half, how much money will the organization have saved 7. From department A until he comes back to department A What is the total distance (in meters) the supervisor travels, if he has to visit all department three times 8. From door 1 which route cost less (how much) to get to department F (Through department A, C, I and H) OR (Through department A, C, E and G) 9. How much does it cost the organization for the inspector to travel department C to department H (Through department E, G and F) 10. From department A: How much money will the company save if they move department H to same location as department C (Through department C and I) He answers only. = toolbar, press ALT+F10 (PC) or ALT+FN+F10 (Mac). Save A Answers Save and Sut e and Submit to save and submit. Click Save all Answers to save all answers. a W Desktop 25°C O​

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
- Ô DU ns 1 How much does it cost the organization when the inspector travels from doo 1 to departme...
Questions