Engineering, 05.09.2021 17:50 Dezshanae4352

(14 The wheelbase of a car is 3-3 m, and the centre of mass is 1 2 m in front of the rear axle and 0-75 m above the ground-level. The coefficient of friction between the wheels and the road is 0-45. Find the maximum acceleration which the car can be given on a level road if it has a rear-wheel drive. Find its maximum deceleration if the braking force on all the wheels is the same and no wheel slip occurs.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Water flows at the rate of 200 i/s upwards through a tapered vertical pipe. the diameter at marks(3) clo5) the bottom is 240 mm and at the top 200 mm and the length is 5m. the pressure at the bottom is 8 bar, and the pressure at the topside is 7.3 bar. determine the head loss through the pipe. express it as a function of exit velocity head.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?

Answers: 2

Answer

You know the right answer?

(14 The wheelbase of a car is 3-3 m, and the centre of mass is 1 2 m in front of the rear axle and 0...

Questions