Engineering, 03.09.2021 05:40 aliyahedwards94
Two technicians are discussing dealership operations. Technician A says that the automotive industry is one of the largest employers in an area. Technician B says that the automotive industry does nothing to support local economies. Who is correct?
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Two technicians are discussing dealership operations. Technician A says that the automotive industry...
Mathematics, 15.01.2021 18:00
SAT, 15.01.2021 18:00
History, 15.01.2021 18:00
English, 15.01.2021 18:00
Mathematics, 15.01.2021 18:00
Mathematics, 15.01.2021 18:00
Mathematics, 15.01.2021 18:00
History, 15.01.2021 18:00
Mathematics, 15.01.2021 18:00
Mathematics, 15.01.2021 18:00
Chemistry, 15.01.2021 18:00
Geography, 15.01.2021 18:00
Mathematics, 15.01.2021 18:00