Engineering, 29.08.2021 08:20 ripbobbyjackson6701

3 m high and 5 m wide wall consists of 16 cm × 22 cm cross-section horizontal bricks ( k = 0 7.2 W/m. K ) K separated by 3 cm thick mortar layers (k = 0.25 W/m. K) The brick wall also consists of 2 cm thick plaster (k = 0.22 W/m. K) layers on each side of brick and 3 cm thick rigid foam (k = 0.026 W/m. K) on the inner side of the wall as shown in Fig. 3.21(a). The indoor and outdoor temperatures are 55 and 25°C and convection heat transfer coefficients on inner and outer sides 10 W/m^2.W/m 2
.K and 25 W/m^2.KW/m
2
.K, respectively. Assume one dimensional heat transfer and disregard radiation, determine the rate of heat transfer through the wall.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

3 m high and 5 m wide wall consists of 16 cm × 22 cm cross-section horizontal bricks ( k = 0 7.2 W/m...

Questions