subject
Engineering, 16.08.2021 20:00 bryantjorell

You are a historian who is compiling information on the changing materials used in a product in one of the categories listed below. Choose a product that uses a variety of materials that have been discussed in this lesson (for example, a car or a tennis racket). Using online or library resources, research past materials used to create the product. Be sure to discuss the materials currently being used for the design and include information on the sustainability of these resources. Your research must also explain why the materials changes were made (for example, safety, cost, or weight). Keep track of your references so that you can document all of the resources used for your report. A Method of Transportation
Sports Equipment
Household Feature
Assignment Guidelines
Prepare a typed 1 page research report with documentation for all resources used.

Submission Requirements
All submissions should include:

Proper grammar, mechanics, and sentence structure
A works cited or bibliography page

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
You are a historian who is compiling information on the changing materials used in a product in one...
Questions
question
Mathematics, 22.10.2020 19:01
question
Mathematics, 22.10.2020 19:01