Engineering, 10.08.2021 02:30 Svetakotok

A balanced bank of delta-connected capacitors is connected in parallel with the load which complex power associated with each phase of a balanced load is 146+191j kVA. The effect is to place a capacitor in parallel with the load in each phase. The line voltage at the terminals of the load thus remains at 2460 V The circuit is operating at a frequency of 65 Hz The capacitors are adjusted so that the magnitude of the line current feeding the parallel combination of the load and capacitor bank is at its minimum. Part A) What is the size of each capacitor? Express your answer in microfarads to three significant figures.
Part B )What is the size of each capacitor if they are wye-connected capacitors? Express your answer in microfarads to three significant figures.
Part C) What is the magnitude of the line current? Express your answer in amperes to three significant figures.

Answers: 1

Show answers

Another question on Engineering

Engineering, 06.07.2019 03:10

Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Steam enters a converging-diverging nozzle at 1.0 mpa and 500°c with a negligible velocity at a mass flow rate of 2.5 kg/s, and it exits at a pressure of 200 kpa. assuming the flow through the nozzle to be isentropic, determine: the exit area and (a) (b) the exit mach number

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg.k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft

Answers: 1

Answer

Engineering, 06.07.2019 04:30

Calculate the equilibrium concentration of vacancies per cubic meter in pure aluminum at 500°c. assume that the energy of formation of a vacancy in pure aluminum is 0.76 ev. what is the vacancy fraction at 650°c.

Answers: 3

Answer

You know the right answer?

A balanced bank of delta-connected capacitors is connected in parallel with the load which complex p...

Questions