Engineering, 09.08.2021 20:50 krystalhurst97

The electric motor exerts a torque of 800 N·m on the steel shaft ABCD when it is rotating at a constant speed. Design specifications require that the diameter of the shaft be uniform from A to D and that the angle of twist between A and D not exceed 1.15°. Knowing that τmax ≤ 60 MPa and G = 77.2 GPa, determine the minimum diameter shaft that can be used. (Round the final answer to one decimal place.) The minimum diameter shaft that can be used is mm.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 3

Answer

You know the right answer?

The electric motor exerts a torque of 800 N·m on the steel shaft ABCD when it is rotating at a const...

Questions