Engineering, 05.08.2021 14:00 dmgcity

Question 1 m(35 marks) The values of the exterior angles in the figure shown, measured by a one second theodolite, are: Angle ABC BCD CDE DEF EFA FAB Mean observed Value 272 03' 10" 272°05' 51" 104° 50' 31" 261° 11'06" 266° 10' 15" 263° 38' 25" (a) Determine the sum of the measured angles. (5 marks) (b)Determine the angular error of the traverse. (5 marks) (c) Adjust the angles of the traverse to eliminate the error. (5 marks) (d) Given that the whole circle bearing of line AB is 43°40'45", calculate the bearings of all other lines of the traverse. (20 marks) The sum of exterior angles = 62n+4) * 90

Question 1 m(35 marks) The values of the exterior angles in the figure shown, measured by a one sec

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

You know the right answer?

Question 1 m(35 marks) The values of the exterior angles in the figure shown, measured by a one seco...

Questions