A symmetric biplane having forward / aft wedge angles 2° is placed in supersonic flow as shown below.
Estimate the lift and drag of this configuration by using the idea of method of
characteristics. (Recall v±0=const on different direction i. e left or right running waves)
%3D
The wave pattern on the biplane is shown in dashed lines.
(v,0)»=(28,0)

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.